Mitsubishi Electric MR-J4-10B(-RJ) Instruction Manual page 546

17. APPLICATION OF FUNCTIONS
(2) Extension control 2 parameters ([Pr. PX_ _ ])
CAUTION
No. Symbol
PX01 **J3EX J3 extension function
PX02 XOP1 Function selection X-1
PX03 VRFTX Vibration suppression control tuning mode (advanced vibration
suppression control II)
PX04 VRF21 Vibration suppression control 2 - Vibration frequency
PX05 VRF22 Vibration suppression control 2 - Resonance frequency
PX06 VRF23 Vibration suppression control 2 - Vibration frequency damping
PX07 VRF24 Vibration suppression control 2 - Resonance frequency damping
PX08 VRF21B Vibration suppression control 2 - Vibration frequency after gain switching
PX09 VRF22B Vibration suppression control 2 - Resonance frequency after gain
switching
PX10 VRF23B Vibration suppression control 2 - Vibration frequency damping after gain
switching
PX11 VRF24B Vibration suppression control 2 - Resonance frequency damping after
gain switching
PX12 PG1B Model loop gain after gain switching
PX13 *XOP2 Function selection X-2
PX14 OTHOV One-touch tuning - Overshoot permissible level
PX15 For manufacturer setting
PX16
PX17 NH3 Machine resonance suppression filter 3
Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
Do not change the parameter settings as described below. Doing so may cause
an unexpected condition, such as failing to start up the servo amplifier.
Changing the values of the parameters for manufacturer setting
Setting a value out of the range
Changing the fixed values in the digits of a parameter
When you write parameters with the controller, make sure that the control axis No.
of the servo amplifier is set correctly. Otherwise, the parameter settings of another
axis may be written, possibly causing the servo amplifier to be an unexpected
condition.
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: After setting the parameter, cycle the power or reset the controller.
**: After setting the parameter, cycle the power.
Abbreviations of J3 compatibility mode indicate the followings.
Standard: Standard (semi closed loop system) use of the rotary servo motor
Full.: Fully closed loop system use of the rotary servo motor
Lin.: Linear servo motor use
DD: Direct drive (DD) motor use
Name
17 - 15
compatibility
mode
Initial
Unit
value
0000h
0000h
0000h
100.0 [Hz]
100.0 [Hz]
0.00
0.00
0.0 [Hz]
0.0 [Hz]
0.00
0.00
0.0 [rad/s]
0001h
0 [%]
0000h
0000h
4500 [Hz]
J3