I/O Setting Parameters ([Pr. Pd - Mitsubishi Electric MR-J4-10B(-RJ) Instruction Manual

5. PARAMETERS
No. Symbol
PC38 ERW Error excessive warning level
Set an error excessive warning level.
To enable the parameter, select "Enabled (1 _ _ _)" of "[AL. 9B Error excessive warning]
selection" in [Pr. PC05].
You can change the setting unit with "Error excessive alarm/error excessive warning level unit
selection" in [Pr. PC06].
Set this per rev. for rotary servo motors and direct drive motors. Setting "0" will be "1 rev", and
setting over 200 rev will be clamped with 200 rev. Set this per mm for linear servo motors.
Setting "0" will be 50 mm.
When an error reaches the set value, [AL. 9B Error excessive warning] will occur. When the
error decreases lower than the set value, the warning will be canceled automatically. The
minimum pulse width of the warning signal is 100 [ms].
Set as follows.: [Pr. PC38 Error excessive warning level] < [Pr. PC01 Error excessive alarm
level] When you set as follows, [AL. 52 Error excessive] will occur earlier than the warning.:
[Pr. PC38 Error excessive warning level] ≥ [Pr. PC01 Error excessive alarm level]
This parameter is used by servo amplifier with software version B4 or later.

5.2.4 I/O setting parameters ([Pr. PD_ _ ])

No. Symbol
PD02 *DIA2 Input signal automatic on selection 2
Setting digit
HEX.
_ _ _ x
_ _ x _
_ x _ _
x _ _ _
Convert the setting value into hexadecimal as follows.
0 0 0
When performing a magnetic pole detection without using FLS (Upper stroke limit) and RLS
(Lower stroke limit), you can disable FLS and RLS by setting [Pr. PL08 Linear servo motor/DD
motor function selection 3] to "_ 1 _ _".
Name and function
Name and function
BIN.
_ _ _ x FLS (Upper stroke limit) selection
0: Disabled
1: Enabled
_ _ x _ RLS (Lower stroke limit) selection
0: Disabled
1: Enabled
_ x _ _ For manufacturer setting
x _ _ _
For manufacturer setting
FLS (Upper stroke limit) selection
RLS (Lower stroke limit) selection
BIN 0: Use for an external input signal.
BIN 1: Automatic on
5 - 42
Explanation
Initial value
Signal name
BIN HEX
Initial
value
[unit]
0
[rev]/
[mm]
Initial
value
[unit]
Refer to the
"Name and
Initial
function" column.
value
0h
0h
0h
0h
0
0
0
0
0
Setting
range
0
to
1000
Setting
range