Mitsubishi Electric MR-J4-10B(-RJ) Instruction Manual page 100

3. SIGNALS AND WIRING
You can also use a ferrule to connect with the connectors. When using a ferrule, select a ferrule and
crimping tool listed in the table below.
Servo amplifier
MR-J4-10B(-RJ) to
MR-J4-100B(-RJ)
MR-J4-200B(-RJ) to
MR-J4-350B(-RJ)
MR-J4-60B4(-RJ) to
MR-J4-350B4(-RJ)
MR-J4-10B1(-RJ) to
MR-J4-40B1(-RJ)
(b) Inserting wire
Insert only one wire or ferrule to each wire insertion hole.
Insert the open tool as follows and push it down to open the spring. While the open tool is pushed
down, insert the stripped wire into the wire insertion hole. Check the wire insertion depth, and make
sure that the cable insulator will not be caught by the spring and that the conductive part of the
stripped wire will not be exposed.
Release the open tool to fix the wire. Pull the wire lightly to confirm that the wire is surely connected.
In addition, make sure that no conductor wire sticks out of the connector.
The following shows a connection example of the CNP3 connector for MR-J4-200B(-RJ) and MR-J4-
350B(-RJ).
Ferrule model (Phoenix Contact)
Wire size
For one
AWG 16 AI1.5-10BK
AWG 14 AI2.5-10BU
AWG 16 AI1.5-10BK
AWG 14 AI2.5-10BU
AWG 12 AI4-10GY
AWG 16 AI1.5-10BK
AWG 14 AI2.5-10BU
AWG 16 AI1.5-10BK
AWG 14 AI2.5-10BU
3 - 23
For two
AI-TWIN2×1.5-10BK
AI-TWIN2×1.5-10BK
AI-TWIN2×2.5-10BU
AI-TWIN2×1.5-10BK
AI-TWIN2×1.5-10BK
1) Push down the open tool.
3) Release the open tool to fix the wire.
2) Insert the wire.
Crimping tool
(Phoenix Contact)
CRIMPFOX-ZA3