Status Display Mode; Display Exapmles; Status Display List - Mitsubishi Electric Melservo-H Series Specifications And Instruction Manual

4. DISPLAY SECTION AND OPERATION SECTION OF THE CONVERTER UNIT

4.2 Status display mode

The servo status during operation is shown on the 4-digit, 7-segment LED display. Press the "UP" or
"DOWN" button to change display data as desired.
When the required data is selected, the corresponding symbol is displayed. Press the "SET" button to
display that data.
The converter unit display section can show four items of data such as the effective load factor.
4.2.1 Display examples
The following table shows the display examples.
Item
Bus voltage
Effective load factor
Peak load factor
Regenerative load factor

4.2.2 Status display list

The following table lists the servo statuses that may be displayed.
Status Display
Bus voltage
Effective load factor
Peak load factor
Regenerative load
factor
Note: Output speed
Symbol Unit
d V The converter unit voltage is displayed.
Continuous effective load torque is displayed. (Note)
J % The effective value is displayed relative to the rated
torque of 100%.
The peak output is displayed. (Note)
b %
The peak value in the past 15 seconds is displayed
relative to the rated torque of 100%.
The percentage of regnerative power to the
L %
permissible regenerative value is displaed.
torque
Status
225[V]
67[%]
95[%]
90[%]
Description
4 - 2
Display
Indication Range
150 to 500
0 to 300
0 to 300
0 to 300