Loading Files - Sony MVS-8000X User Manual

Loading Files

As an example, to load a snapshot file from hard disk or memory card to a
register, use the following procedure.
1
2
3
4
5
Loading frame memory files
Between steps 3 and 4 of the procedure above, "Loading Files," do as follows.
Notes
• When the signal format is 1080P, extended clip files cannot be recalled.
• In a still image file saved in the 1080P signal format, there are two still image
files for each frame. If either of these two files is missing, it is not possible
448
Operations on Individual Files
• To display all types of file, press [All].
In the File menu, select VF3 'Snapshot' and HF1 'Snapshot.'
In the device selection area on the left, select [Register].
In the device selection area on the right, select where the file is held
([HDD] or [Memory Card]), and then specify a directory.
See "Selecting a Device for Operations" (page 445).
Using any of the following methods, select the register to which you want
to load, and the file to be loaded.
• To select all files within the list, press [ALL] below the list.
• To select multiple files, turn the knobs to select in the following ranges.
Knob Parameter Adjustment
1 List L Select the first register into which the
data is to be loaded
2 List R Select the first file in which data is held
3 Num Number to be selected
• To select a single file, press the arrow keys to scroll the reverse video
cursor, or press directly on the list in the status area.
Press [T Load].
This loads the contents of the selected file from the specified location.
(Setup data is first loaded.)
Setting values
1 to 99
1 to 99
1 to 99