Rip Configuration Examples; Configuring Basic Rip - HP FlexFabric 12900E Series Configuration Manual

Task
Display RIP interface information.
Display neighbor information for a RIP process.
Display RIP NSR information.
Display routing information for a RIP process.
Reset a RIP process.
Clear the statistics for a RIP process.

RIP configuration examples

Configuring basic RIP

Network requirements
As shown in
to not advertise route 10.2.1.0/24 to Switch A, and to accept only route 2.1.1.0/24 from Switch A.
Figure 7 Network diagram
Vlan-int101
3.1.1.1/24
Vlan-int102
2.1.1.1/24
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP by using either of the following methods:
(Method 1) # Enable RIP on the specified networks on Switch A.
<SwitchA> system-view
[SwitchA] rip
[SwitchA-rip-1] network 1.0.0.0
[SwitchA-rip-1] network 2.0.0.0
[SwitchA-rip-1] network 3.0.0.0
[SwitchA-rip-1] quit
(Method 2) # Enable RIP on the specified interfaces on Switch B.
<SwitchB> system-view
[SwitchB] rip
[SwitchB-rip-1] quit
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] rip 1 enable
[SwitchB-Vlan-interface100] quit
[SwitchB] interface vlan-interface 101
Figure 7, enable RIPv2 on all interfaces on Switch A and Switch B. Configure Switch B
Vlan-int100
1.1.1.1/24
Vlan-int100
1.1.1.2/24
Switch A
Command
display rip process-id interface [ interface-type
interface-number ]
display rip process-id neighbor [ interface-type
interface-number ]
display rip [ process-id ] non-stop-routing
display rip
{ mask-length | mask } [ verbose ] | peer ip-address |
statistics ]
reset rip process-id process
reset rip process-id statistics
Vlan-int101
10.2.1.1/24
Vlan-int102
10.1.1.2/24
Switch B
42
route
process-id [ ip-address