HP FlexFabric 12900E Series Configuration Manual page 71

Figure 15 Network diagram
101.1.1.0/24
Vlan-int300
Switch A
Table 7 Interface and IP address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Switch D
Switch D
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP and enable static route redistribution into RIP so Switch A and Switch C
have routes to send to each other:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] rip 1
[SwitchA-rip-1] version 2
[SwitchA-rip-1] undo summary
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 101.1.1.0
[SwitchA-rip-1] peer 192.168.2.2
[SwitchA-rip-1] undo validate-source-address
[SwitchA-rip-1] import-route static
[SwitchA-rip-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] rip bfd enable
[SwitchA-Vlan-interface100] quit
[SwitchA] rip 2
[SwitchA-rip-2] version 2
Switch D
Vlan-int300
Switch B
Vlan-int100
Vlan-int100
BFD
Interface
VLAN-interface 300
VLAN-interface 100
VLAN-interface 100
VLAN-interface 200
VLAN-interface 200
VLAN-interface 400
VLAN-interface 300
VLAN-interface 400
Vlan-int400
Vlan-int400
Vlan-int200
Vlan-int200
Switch C
IP address
192.168.3.1/24
192.168.1.1/24
192.168.1.2/24
192.168.2.1/24
192.168.2.2/24
192.168.4.2/24
192.168.3.2/24
192.168.4.1/24
59
100.1.1.0/24