Setting The Maximum Number Of Ospfv3 Ecmp Routes; Setting A Preference For Ospfv3 - HP FlexFabric 12900E Series Configuration Manual

Step
2. Enter interface view.
3. Set an OSPFv3 cost for the
interface.
To set a bandwidth reference value:
Step
1. Enter system view.
2. Enter OSPFv3 view.
3. Set a bandwidth reference
value.

Setting the maximum number of OSPFv3 ECMP routes

Perform this task to implement load sharing over ECMP routes.
To set the maximum number of ECMP routes:
Step
1. Enter system view.
2. Enter OSPFv3 view.
3. Set the maximum number of
ECMP routes.

Setting a preference for OSPFv3

A router can run multiple routing protocols. The system assigns a priority for each protocol. When
these routing protocols find the same route, the route found by the protocol with the highest priority is
selected.
To set a preference for OSPFv3:
Step
1. Enter system view.
2. Enter OSPFv3 view.
Command
interface
interface-type
interface-number
ospfv3 cost
[ instance instance-id ]
Command
system-view
ospfv3 [ process-id
vpn-instance
vpn-instance-name ] *
bandwidth-reference value
Command
system-view
ospfv3
[ process-id
vpn-instance
vpn-instance-name ] *
maximum load-balancing
number
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
407
Remarks
N/A
By default, the OSPFv3 cost is 1 for
a VLAN interface, is 0 for a loopback
cost-value
interface. The OSPFv3 cost is
automatically computed according
to the interface bandwidth for other
interfaces.
Remarks
N/A
|
N/A
The default setting is 100 Mbps.
Remarks
N/A
|
N/A
By default, the maximum number
of ECMP routes equals the
maximum
routes supported by the system.
Remarks
N/A
N/A
number of ECMP