Bfd For Static Routes Configuration Example (Direct Next Hop) - HP FlexFabric 12900E Series Configuration Manual

Destination/Mask
0.0.0.0/0
Static Routing table Status : <Inactive>
Summary Count : 0
# Display static routes on Switch B.
[SwitchB] display ip routing-table protocol static
Summary Count : 2
Static Routing table Status : <Active>
Summary Count : 2
Destination/Mask
1.1.2.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
# Use the ping command on Host B to test the reachability of Host A (Windows XP runs on the two
hosts).
C:\Documents and Settings\Administrator>ping 1.1.2.2
Pinging 1.1.2.2 with 32 bytes of data:
Reply from 1.1.2.2: bytes=32 time=1ms TTL=126
Reply from 1.1.2.2: bytes=32 time=1ms TTL=126
Reply from 1.1.2.2: bytes=32 time=1ms TTL=126
Reply from 1.1.2.2: bytes=32 time=1ms TTL=126
Ping statistics for 1.1.2.2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 1ms, Average = 1ms
# Use the tracert command on Host B to test the reachability of Host A.
C:\Documents and Settings\Administrator>tracert 1.1.2.2
Tracing route to 1.1.2.2 over a maximum of 30 hops
1 <1 ms
2 <1 ms
3 1 ms
Trace complete.

BFD for static routes configuration example (direct next hop)

Network requirements
Configure the following, as shown in
Proto Pre Cost
Static 60 0
Proto Pre Cost
Static 60 0
<1 ms <1 ms 1.1.6.1
<1 ms <1 ms 1.1.4.1
<1 ms <1 ms 1.1.2.2
Figure
NextHop
1.1.4.2
NextHop
1.1.4.1
3:
15
Interface
Vlan500
Interface
Vlan500