Configuring Bfd For Bgp - HP FlexFabric 12900E Series Configuration Manual

Step
3. Enable logging for BGP
route flapping.

Configuring BFD for BGP

IMPORTANT:
If you have enabled GR, use BFD with caution because BFD might detect a failure before the
system performs GR, which will result in GR failure. If you have enabled both BFD and GR for BGP,
do not disable BFD during a GR process to avoid GR failure.
BGP maintains neighbor relationships based on the keepalive timer and hold timer in seconds. It
requires that the hold time must be at least three times the keepalive interval. This mechanism slows
down link failure detection. Once a failure occurs on a high-speed link, a large quantity of packets will
be dropped before routing convergence completes. BFD for BGP can solve this problem by fast
detecting link failures to reduce convergence time.
Before you enable BFD for a BGP peer or peer group, you must establish a BGP session between
the local router and the peer or peer group.
For more information about BFD, see High Availability Configuration Guide.
To enable BFD for a BGP peer (IPv4 unicast/multicast address family):
Step
1. Enter system view.
2. Enter
BGP-VPN instance view.
3. Enable BFD to detect the link to the
specified BGP peer or peer group.
To enable BFD for a BGP peer (IPv6 unicast address family):
Step
1. Enter system view.
Command
log-route-flap
monitor-count [ log-count-limit |
route-policy route-policy-name ] *
BGP instance view
monitor-time
Command
system-view
•
Enter BGP
bgp as-number
instance-name
[ multi-session-thread ]
•
Enter BGP-VPN instance view:
or
a. bgp as-number [ instance
instance-name
[ multi-session-thread ]
b. ip
vpn-instance-name
peer { group-name | ipv4-address
[ mask-length ] } bfd [ multi-hop |
single-hop ]
Command
system-view
288
Remarks
By default, logging for BGP route
flapping is disabled.
Remarks
N/A
instance view:
[ instance
]
N/A
]
vpn-instance
By default, BFD is
disabled.
Remarks
N/A