Protocols And Standards; Ripng Configuration Task List; Configuring Basic Ripng - HP FlexFabric 12900E Series Configuration Manual

4. A response packet that fails the check is discarded.

Protocols and standards

•
RFC 2080, RIPng for IPv6
•
RFC 2081, RIPng Protocol Applicability Statement

RIPng configuration task list

Tasks at a glance
(Required.)
(Optional.) Configuring RIPng route
•
Configuring an additional routing metric
•
Configuring RIPng route summarization
•
Advertising a default route
•
Configuring received/redistributed route filtering
•
Setting a preference for RIPng
•
Configuring RIPng route redistribution
(Optional.) Tuning and optimizing the RIPng
•
Setting RIPng timers
•
Configuring split horizon and poison reverse
•
Configuring zero field check on RIPng packets
•
Setting the maximum number of ECMP routes
•
Configuring the RIPng packet sending rate
•
Setting the interval for sending triggered updates
(Optional.) Configuring RIPng GR
(Optional.) Configuring RIPng NSR
(Optional.) Configuring RIPng FRR

Configuring basic RIPng

Before you configure basic RIPng, configure IPv6 addresses for interfaces to ensure IPv6
connectivity between neighboring nodes.
To configure basic RIPng:
Step
1. Enter system view.
2. Enable RIPng and enter its
view.
3. Return to system view.
4. Enter interface view.
Configuring basic RIPng
control:
network:
Command
system-view
ripng [ process-id
vpn-instance
[
vpn-instance-name ]
quit
interface interface-type
interface-number
379
Remarks
N/A
]
By default, RIPng is disabled.
N/A
N/A