Task
Display routing information about
a specified RIP process.
Reset a RIP process.
Clear the statistics of a RIP process.
RIP configuration examples
Configuring RIP version
Network requirements
As shown in
Figure 7 Network diagram
Configuration procedure
Configure an IP address for each interface. (Details not shown.)
1.
Configure basic RIP functions:
2.
# Configure Switch A.
[SwitchA] rip
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 172.16.0.0
[SwitchA-rip-1] network 172.17.0.0
[SwitchA-rip-1] quit
# Configure Switch B.
[SwitchB] rip
[SwitchB-rip-1] network 192.168.1.0
[SwitchB-rip-1] network 10.0.0.0
[SwitchB-rip-1] quit
# Display the RIP routing table on Switch A.
[SwitchA] display rip 1 route
Route Flags: R - RIP, T - TRIP
----------------------------------------------------------------------------
Peer 192.168.1.2
Figure
7, enable RIPv2 on all interfaces on Switch A and Switch B.
P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect
on Vlan-interface100
Destination/Mask
Command
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
reset rip process-id process
reset rip process-id statistics
Nexthop
Cost
33
Remarks
Available in any view
Available in user view
Available in user view
Tag
Flags
Sec