Is-Is Route Redistribution Configuration Example - HP FlexFabric 12900E Series Configuration Manual

Interface: Vlan-interface100
State: Up
System Id: 0000.0000.0001
Interface:
State: Up
[SwitchC] display isis interface
Interface: Vlan-interface100
Index
00001
# Display information about IS-IS neighbors and interfaces on Switch D.
[SwitchD] display isis peer
System Id: 0000.0000.0001
Interface: Vlan-interface100
State: Up
System Id: 0000.0000.0002
Interface: Vlan-interface100
State: Up
[SwitchD] display isis interface
Interface:
Index
00001

IS-IS route redistribution configuration example

Network requirements
As shown in
IS-IS to interconnect. Switch A and Switch B are Level-1 routers, Switch D is a Level-2 router, and
Switch C is a Level-1-2 router.
Redistribute RIP routes into IS-IS on Switch D.
HoldTime: 25s
Vlan-interface100
HoldTime: 7s
Interface information for IS-IS(1)
----------------------------------
IPv4.State
Up
HoldTime: 9s
HoldTime: 28s
Interface information for IS-IS(1)
----------------------------------
Vlan-interface100
IPv4.State
Up
Figure 44, Switch A, Switch B, Switch C, and Switch D reside in the same AS. They use
Circuit Id: 0000.0000.0001.01
Type: L1
Circuit Id: 0000.0000.0001.01
Type: L1
IPv6.State CircuitID
Down 1
Peer information for IS-IS(1)
----------------------------
Circuit Id: 0000.0000.0001.01
Type: L2
Circuit Id: 0000.0000.0001.01
Type: L2
IPv6.State CircuitID
Down 1
173
PRI: 64
PRI: 100
MTU Type DIS
1497 L1/L2 No/No
PRI: 100
PRI: 64
MTU Type DIS
1497 L1/L2 No/No