Setting Match Criteria For An Ipv6 Node; Configuring Actions For An Ipv6 Node - HP FlexFabric 12900E Series Configuration Manual

Step
2. Create an IPv6 policy
or policy node and
enter its view.

Setting match criteria for an IPv6 node

Step
1. Enter system view.
2. Enter IPv6 policy
node view.
3. Set an ACL match
criterion.
NOTE:
If an ACL match criterion is defined, packets are compared with the ACL rule. The permit or deny
action and the time range of the specified ACL are ignored. If the specified ACL does not exist, no
packet is matched.

Configuring actions for an IPv6 node

Step
1. Enter
view.
2. Enter IPv6 policy
node view.
3. Set
precedence.
4. Set next hops for
permitted
packets.
5. Set default next
hops.
Command
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
Command
system-view
ipv6 policy-based-route policy-name [ deny | permit ]
node node-number
if-match acl { ipv6-acl-number | name ipv6-acl-name }
Command
system
system-view
ipv6 policy-based-route
[ deny | permit ] node node-number
an IP
apply precedence { type | value }
apply next-hop
vpn-instance-name
IPv6
[ direct
track-entry-number ] }&<1-n>
apply default-next-hop [ vpn-instance
vpn-instance-name
[ direct
track-entry-number ] }&<1-n>
policy-name
[ vpn-instance
] { ipv6-address
] [ track
] { ipv6-address
] [ track
468
Remarks
By default, no IPv6 policy
nodes exist.
Remarks
N/A
N/A
By default, no ACL
match criterion is set.
The ACL
criterion
match
information.
Remarks
N/A
N/A
By default, no IP precedence is
specified.
By default, no next hop is specified.
You can specify multiple next hops
for backup in one command line or
by executing this command multiple
times.
You can specify a maximum of two
next hops for a node.
By default, no default next hop is
specified.
You can specify multiple default next
hops for backup in one command
line or by executing this command
multiple times.
You can specify a maximum of two
default next hops for a node.
match
cannot
Layer 2