Configuring Rip Frr - HP FlexFabric 12900E Series Configuration Manual

Verifying the configuration
# Display the BFD session information on Switch A.
<SwitchA> display bfd session
Total Session Num: 1
IPv4 session working under Ctrl mode:
LD/RD
513/513
# Display RIP routes destined for 100.1.1.0/24 on Switch A.
<SwitchA> display ip routing-table 100.1.1.0 24
Summary count : 1
Destination/Mask
100.1.1.0/24
The output shows that Switch A communicates with Switch C through VLAN-interface 100. Then the
link over VLAN-interface 100 fails.
# Display RIP routes destined for 100.1.1.0/24 on Switch A.
<SwitchA> display ip routing-table 100.1.1.0 24
Summary count : 1
Destination/Mask
100.1.1.0/24
The output shows that Switch A communicates with Switch C through VLAN-interface 300.

Configuring RIP FRR

Network requirements
As shown in
when Link A becomes unidirectional, services can be switched to Link B immediately.
Figure 16 Network diagram
Loop0
Switch A
Table 8 Interface and IP address assignment
Device
Switch A
Up Session Num: 1
SourceAddr
192.168.1.1
Proto Pre Cost
RIP 100 1
Proto Pre Cost
RIP 100 2
Figure 16, Switch A, Switch B, and Switch C run RIPv2. Configure RIP FRR so that
Switch C
Vlan-int200
Interface
VLAN-interface 100
Init Mode: Active
DestAddr
192.168.2.2
NextHop
192.168.2.2
NextHop
192.168.3.2
Link B
Link A
Vlan-int200
61
State Holdtime
Up 1700ms
Interface
vlan-interface 100
Interface
vlan-interface 300
Loop0
Switch B
IP address
12.12.12.1/24
Interface
vlan100