Specifying A Policy For Interface Pbr; Specifying A Policy For Outbound Pbr On A Vxlan Tunnel Interface - HP FlexFabric 12900E Series Configuration Manual

Hide thumbs Also See for FlexFabric 12900E Series:
Table of Contents

Advertisement

Step
1.
Enter system view.
2.
Specify a policy for local PBR.

Specifying a policy for interface PBR

You can specify only one policy for interface PBR and must make sure the specified policy already
exists.
Before you can apply a new policy to an interface, you must first remove the current policy from the
interface.
You can apply a policy to multiple interfaces.
To specify a policy for interface PBR on an interface:
Step
1.
Enter
view.
2.
Enter interface
view.
3.
Specify a policy
for
PBR.
4.
Quit
view.
5.
(Optional.)
Specify a policy
for
a
VLAN
interfaces.
Specifying a policy for outbound PBR on a VXLAN tunnel
interface
In a VXLAN network, equal-cost routes might exist between two endpoints of a VXLAN tunnel. The
device cannot route VXLAN packets to the exact next hop. To choose the desired next hop for
outgoing VXLAN packets, use outbound PBR on the VXLAN tunnel interface.
The outbound PBR configuration takes effect only on VXLAN IP gateways.
You can specify only one policy for interface PBR and must make sure the specified policy already
exists.
Before you can apply a new policy to an interface, you must first remove the current policy from the
interface.
To specify a policy for outbound PBR on a VXLAN tunnel interface:
Step
1.
Enter system view.
Command
system
system-view
interface interface-type interface-number
interface
ip policy-based-route policy-name
interface
quit
ip policy-based-route policy-name apply
list
of
vlan-interface interface-list
Command
system-view
Command
system-view
ip
local
policy-based-route
policy-name
362
Remarks
N/A
By default, local PBR is not
enabled.
Remarks
N/A
N/A
By default, no interface policy is
applied to an interface.
N/A
By default, no policy is applied to the
specified VLAN interfaces.
When you want to specify a policy for
multiple VLAN interfaces on a device,
use
this
command
configuration
and
save
resources.
Remarks
N/A
to
simplify
device

Advertisement

Table of Contents
loading

Table of Contents