HP FlexFabric 12900E Series Configuration Manual page 388

Destination IP: 2::9
Session State: Up
Hold Time: 2012ms
The output shows that the BFD session has been created.
# Display the IPv6 static routes on Switch A.
<SwitchA> display ipv6 routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination: 120::/64
NextHop : 2::9
Interface : Vlan10
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates Switch B through VLAN-interface 10. The link over
VLAN-interface 10 fails.
# Display IPv6 static routes on Switch A again.
<SwitchA> display ipv6 routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination: 120::/64
NextHop : 10::100
Interface : Vlan11
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 11.
Interface: N/A
376
Protocol : Static
Preference: 60
Cost : 0
Protocol : Static
Preference: 65
Cost : 0