Configuring Basic Is-Is; Configuration Prerequisites - HP FlexFabric 12900E Series Configuration Manual

Tasks at a glance
(Optional.) Configuring IS-IS route
•
Configuring IS-IS link cost
•
Specifying a preference for IS-IS
•
Configuring the maximum number of ECMP routes
•
Configuring IS-IS route summarization
•
Advertising a default route
•
Configuring IS-IS route redistribution
•
Configuring IS-IS route filtering
•
Configuring IS-IS route leaking
(Optional.) Tuning and optimizing IS-IS
•
Specifying the interval for sending IS-IS hello packets
•
Specifying the IS-IS hello multiplier
•
Specifying the interval for sending IS-IS CSNP packets
•
Configuring a DIS priority for an interface
•
Disabling an interface from sending/receiving IS-IS packets
•
Enabling an interface to send small hello packets
•
Configuring LSP parameters
•
Controlling SPF calculation interval
•
Configuring convergence priorities for specific routes
•
Setting the LSDB overload bit
•
Configuring the ATT bit
•
Configuring the tag value for an interface
•
Configuring system ID to host name mappings
•
Enabling the logging of neighbor state changes
•
Enabling IS-IS ISPF
•
Enabling prefix suppression
•
Configuring IS-IS network management
•
Configuring IS-IS PIC
(Optional.) Enhancing IS-IS network
•
Configuring neighbor relationship authentication
•
Configuring area authentication
•
Configuring routing domain authentication
(Optional.) Configuring IS-IS GR
(Optional.) Configuring IS-IS NSR
(Optional.) Configuring BFD for IS-IS
(Optional.) Configuring IS-IS FRR

Configuring basic IS-IS

Configuration prerequisites

Before the configuration, complete the following tasks:
•
Configure the link layer protocol.
•
Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
control:
networks:
security:
140