Configuring Static Route Frr To Automatically Select A Backup Next Hop; Enabling Bfd Echo Packet Mode For Static Route Frr; Displaying And Maintaining Static Routes - HP FlexFabric 12900E Series Configuration Manual

Configuring static route FRR to automatically select a backup
next hop
Step
1. Enter system view.
2. Configure static route FRR to
automatically
backup next hop.

Enabling BFD echo packet mode for static route FRR

By default, static route FRR uses ARP to detect primary link failures. Perform this task to enable
static route FRR to use BFD echo packet mode for fast failure detection on the primary link.
To enable BFD echo packet mode for static route FRR:
Step
1. Enter system view.
2. Configure the source IP
address of BFD echo
packets.
3. Enable BFD echo packet
mode for static route FRR.

Displaying and maintaining static routes

Execute display commands in any view.
Task
Display static route information.
Display static route next hop
information.
Display static
information.
Command
system-view
select a
ip route-static fast-reroute auto
Command
system-view
bfd echo-source-ip ip-address
ip
primary-path-detect bfd echo
Command
display ip routing-table protocol static [ inactive | verbose ]
display route-static nib [ nib-id ] [ verbose ]
display
routing table
vpn-instance-name ] [ ip-address { mask-length | mask } ]
route-static
route-static routing-table
13
Remarks
N/A
By default, static route FRR is
disabled from automatically
selecting a backup next hop.
Remarks
N/A
By default, the source IP address
of BFD echo packets is not
configured.
The source IP address cannot be
on the same network segment as
any local interface's IP address.
For more information about this
command, see High Availability
Command Reference.
By default, BFD echo mode for
static route FRR is disabled.
vpn-instance
[