6Pe Configuration Example - HP FlexFabric 12900E Series Configuration Manual

NextHop : ::
PrefVal : 32768
MED
Path/Ogn: i
* i Network : 102::
NextHop : 102::1
PrefVal : 0
MED
Path/Ogn: i
The output shows that Switch D has learned the network 1::/64 from Switch C through route
reflection.

6PE configuration example

Network requirements
As shown in
•
The ISP uses OSPF as the IGP.
•
PE 1 and PE 2 are edge devices of the ISP, and establish an IPv4 IBGP connection between
them.
•
CE 1 and CE 2 are edge devices of the IPv6 networks, and they connect the IPv6 networks to
the ISP.
•
A CE and a PE exchange IPv6 packets through IPv6 static routing.
Figure 81 Network diagram
Loop0
1::1/128
IPv6 network
Configuration procedure
1. Configure IPv6 addresses and IPv4 addresses for interfaces. (Details not shown.)
2. Configure PE 1:
# Enable LDP globally, and configure the LSP generation policy.
<PE1> system-view
[PE1] mpls lsr-id 2.2.2.2
[PE1] mpls ldp
[PE1-ldp] lsp-trigger all
[PE1-ldp] quit
# Enable MPLS and LDP on VLAN-interface 30.
: 0
: 0
Figure 81, use 6PE to connect two isolated IPv6 networks over an IPv4/MPLS network.
Loop0
2.2.2.2/32
Vlan-int30
1.1.1.1/16
Vlan-int10
10::2/64
PE 1
IPv4/MPLS network
Vlan-int10
10::1/64
CE 1
AS 65100
Loop0
3.3.3.3/32
Vlan-int30
1.1.1.2/16
IBGP
PE 2
Vlan-int20
347
LocPrf :
OutLabel : NULL
PrefixLen : 96
LocPrf : 100
OutLabel : NULL
Vlan-int20
20::2/64
Loop0
4::4/128
20::1/64
CE 2
IPv6 network