Tasks at a glance
(Optional.)
•
Setting OSPF timers
•
Setting LSA transmission delay
•
Setting SPF calculation interval
•
Setting the LSA arrival interval
•
Setting the LSA generation interval
•
Disabling interfaces from receiving and sending OSPF packets
•
Configuring stub routers
•
Configuring OSPF authentication
•
Adding the interface MTU into DD packets
•
Setting the DSCP value for outgoing OSPF packets
•
Setting the maximum number of external LSAs in LSDB
•
Setting OSPF exit overflow interval
•
Enabling compatibility with RFC 1583
•
Logging neighbor state changes
•
Configuring OSPF network management
•
Setting the LSU transmit rate
•
Setting the maximum length of OSPF packets that can be sent by an interface
•
Enabling OSPF ISPF
•
Configuring prefix suppression
•
Configuring prefix prioritization
•
Configuring OSPF PIC
•
Setting the number of OSPF logs
•
Filtering outbound LSAs on an interface
•
Filtering LSAs for the specified neighbor
•
Configuring GTSM for OSPF
(Optional.)
•
Configuring OSPF GR restarter
•
Configuring OSPF GR helper
•
Triggering OSPF GR
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Enabling OSPF
Enable OSPF before you perform other OSPF configuration tasks.
Configuration prerequisites
Configure the link layer protocol and IP addresses for interfaces to ensure IP connectivity between
neighboring nodes.
Tuning and optimizing OSPF
Configuring OSPF GR
Configuring OSPF NSR
Configuring BFD for OSPF
Configuring OSPF FRR
Advertising OSPF link state information to BGP
networks:
72