Static Route Frr Configuration Example - HP FlexFabric 12900E Series Configuration Manual

# Display the static routes on Switch A.
<SwitchA> display ip routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 10. Then the
link over VLAN-interface 10 fails.
# Display static routes on Switch A.
<SwitchA> display ip routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 11.

Static route FRR configuration example

Network requirements
As shown in
static route FRR. When Link A becomes unidirectional, traffic can be switched to Link B immediately.
Figure 5 Network diagram
Loop0
Switch A
Proto Pre
Static 60
Proto Pre
Static 65
Figure 5, configure static routes on Switch A, Switch B, and Switch C, and configure
Switch C
Vlan-int200
Cost NextHop
0 12.1.1.2
Cost NextHop
0 10.1.1.100
Link B
Link A
Vlan-int200
20
Interface
Vlan10
Interface
Vlan11
Loop0
Switch B