Configuration Prerequisites; Configuring Rip Frr; Enabling Bfd For Rip Frr; Displaying And Maintaining Rip - HP FlexFabric 12900E Series Configuration Manual

Configuration prerequisites

You must specify a next hop by using the apply fast-reroute backup-interface command in a
routing policy and reference the routing policy for FRR. For more information about routing policy
configuration, see

Configuring RIP FRR

Step
1. Enter system view.
2. Enter RIP view.
3. Configure RIP FRR.

Enabling BFD for RIP FRR

By default, RIP FRR does not use BFD to detect primary link failures. To speed up RIP convergence,
enable BFD single-hop echo detection for RIP FRR to detect primary link failures.
To configure BFD for RIP FRR:
Step
1. Enter system view.
2. Configure
address
packets.
3. Enter interface view.
4. Enable BFD for RIP FRR.

Displaying and maintaining RIP

Execute display commands in any view and execute reset commands in user view.
Task
Display RIP current status and configuration
information.
Display active routes in the RIP database.
Display RIP GR information.
"Configuring routing
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
fast-reroute
route-policy-name
Command
system-view
the source IP
of BFD echo
bfd echo-source-ip ip-address
interface
interface-number
rip
echo
policies."
route-policy
interface-type
primary-path-detect
Command
display rip [ process-id ]
display rip process-id database [ ip-address
{ mask-length | mask } ]
display rip [ process-id ] graceful-restart
41
Remarks
N/A
N/A
By default, RIP FRR is disabled.
Remarks
N/A
By default, the source IP address
of BFD echo packets is not
configured.
The source IP address cannot be
on the same network segment as
any local interface's IP address.
For more information about this
command, see High Availability
Command Reference.
N/A
bfd By default, BFD for RIP FRR is
disabled.