HP FlexFabric 12900E Series Configuration Manual page 227

Step
5. Add a peer into the EBGP
peer group.
6. (Optional.) Configure
description for
group.
7. Create the BGP IPv6 unicast
address family or BGP-VPN
IPv6 unicast address family
and enter its view.
8. Enable the router
exchange IPv6
routing information
peers in the specified peer
group.
To configure an EBGP peer group by using Method 1 (IPv4 multicast address family):
Step
1. Enter system view.
2. Enter BGP instance view.
3. Create an EBGP peer group.
4. Specify the AS number of the
group.
5. Add an IPv4 BGP peer into
the EBGP peer group.
6. (Optional.) Configure
description for
group.
7. Create the BGP
multicast address family and
enter its view.
8. Enable the router
exchange IPv4
routing information used for
RPF check with peers in the
specified peer group.
To configure an EBGP peer group by using Method 2 (IPv4 unicast address family):
Command
peer ipv6-address [ prefix-length ]
group group-name [ as-number
as-number ]
a
peer group-name
the peer
text
address-family ipv6 [ unicast ]
to
unicast
with
peer group-name enable
Command
system-view
bgp as-number
instance-name
[ multi-session-thread ]
group group-name external
peer group-name
as-number
peer ipv4-address [ mask-length ]
group group-name [ as-number
as-number ]
a
peer group-name
the peer
text
IPv4
address-family ipv4 multicast
to
unicast
peer group-name enable
215
Remarks
By default, no peers exist in the
peer group.
The as-number
option, if used, must specify the
same AS number as the peer
group-name
as-number command.
description By default, no description is
configured for the peer group.
By default, no BGP IPv6 unicast
address family or BGP-VPN IPv6
unicast address family exists.
By default, the router cannot
exchange IPv6 unicast routing
information with the peers.
Remarks
N/A
[ instance
] N/A
By default, no EBGP peer groups
exist.
By default, no AS number is
specified.
as-number
If a peer group contains peers,
you cannot remove or change its
AS number.
By default, no peers exist in the
peer group.
The as-number
option, if used, must specify the
same AS number as the peer
group-name
as-number command.
description By default, no description is
configured for the peer group.
By default, no BGP IPv4 multicast
address family exists.
By default, the router cannot
exchange IPv4 unicast routing
information used for RPF check
with the peers in the group.
as-number
as-number
as-number
as-number