Displaying And Maintaining Rip; Rip Configuration Examples; Configuring Basic Rip - HP 5500 EI series Configuration Manual

Configuration prerequisites
You must specify a next hop by using the apply fast-reroute backup-interface command in a routing
policy and reference the routing policy for FRR. For more information about routing policy configuration,
see "Configuring routing policies."
Configuration procedure
To configure RIP FRR:
Step
1. Enter system view.
2. Configure the source address
of echo packets.
3. Enter RIP view.
Configure RIP FRR.
4.

Displaying and maintaining RIP

Execute display commands in any view and execute reset commands in user view.
Task
Display RIP current status and configuration
information.
Display active routes in RIP database.
Display RIP interface information.
Display routing information about a specified RIP
process.
Reset a RIP process.
Clear the statistics of a RIP process.

RIP configuration examples

Configuring basic RIP

Network requirements
As shown in
advertise route 10.2.1.0/24 to Router A, and to accept only route 2.1.1.0/24 from Router A.
Figure 7, enable RIPv2 on all interfaces on Router A and Router B. Configure Router B to not
Command
system-view
bfd echo-source-ip ip-address
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
fast-reroute route-policy
route-policy-name
Command
display rip [ process-id ]
display rip process-id database [ ip-address { mask |
mask-length } ]
display rip process-id interface [ interface-type
interface-number ]
display rip process-id route [ ip-address { mask |
mask-length } [ verbose ] | peer ip-address | statistics ]
reset rip process-id process
reset rip process-id statistics
37
Remarks
N/A
By default, the source address of
echo packets is not configured.
N/A
By default, RIP FRR is disabled.