Setting The Lsu Transmit Rate; Configuring Stub Routers - HP FlexFabric 12900E Series Configuration Manual

To configure OSPFv3 network management:
Step
1. Enter system view.
2. Bind MIB to an OSPFv3
process.
3. Enable SNMP notifications
for OSPFv3.
4. Enter OSPFv3 view.
5. Configure
context for the OSPFv3
process.
6. (Optional.) Set the SNMP
notification output interval
and the maximum number
of SNMP notifications that
can be output at each
interval.

Setting the LSU transmit rate

Sending large numbers of LSU packets affects router performance and consumes a large amount of
network bandwidth. You can configure the router to send LSU packets at an interval and to limit the
maximum number of LSU packets sent out of an OSPFv3 interface at each interval.
To set the LSU transmit rate:
Step
1. Enter system view.
2. Enter
view.
3. Set
transmit rate.

Configuring stub routers

A stub router is used for traffic control. It reports its status as a stub router to neighboring OSPFv3
routers. The neighboring routers can have a route to the stub router, but they do not use the stub
router to forward data.
Use either of the following methods to configure a router as a stub router:
Command
system-view
ospfv3 mib-binding process-id
snmp-agent trap enable ospfv3
[
grhelper-status-change
if-state-change
if-bad-pkt | neighbor-state-change |
nssatranslator-status-change
virtif-bad-pkt
virtif-state-change
virtgrhelper-status-change
virtneighbor-state-change ]*
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
an SNMP
snmp context-name context-name
snmp
trap-interval count trap-number
Command
system-view
OSPFv3
ospfv3
vpn-instance-name ] *
the LSU
transmit-pacing interval interval count count
grrestarter-status-change
| if-cfg-error
virtif-cfg-error
|
trap rate-limit
vpn-instance
[ process-id |
413
Remarks
N/A
By default, MIB is bound to the
process with
process ID.
|
|
|
By default, SNMP notifications
| for OSPFv3 are enabled.
|
|
|
N/A
By default, no SNMP context is
configured for the OSPFv3
process.
By default, OSPFv3 outputs a
interval
maximum of seven SNMP
notifications
seconds.
Remarks
N/A
N/A
By default,
interface sends a maximum of
three LSU packets every 20
milliseconds.
the smallest
within 10
an OSPFv3