Setting The Maximum Number Of Ecmp Routes; Configuring The Ripng Packet Sending Rate - HP FlexFabric 12900E Series Configuration Manual

Hide thumbs Also See for FlexFabric 12900E Series:
Table of Contents

Advertisement

Step
2.
Enter RIPng view.
3.
Enable the zero field check
on incoming RIPng packets.

Setting the maximum number of ECMP routes

Step
1.
Enter system view.
2.
Enter RIPng view.
3.
Set the maximum number
of ECMP routes.

Configuring the RIPng packet sending rate

Perform this task to specify the interval for sending RIPng packets and the maximum number of
RIPng packets that can be sent at each interval. This feature can avoid excessive RIPng packets
from affecting system performance and consuming too much bandwidth.
To configure the RIPng packet sending rate:
Step
1.
Enter system view.
2.
Enter RIPng view.
3.
Set the interval for sending
RIPng
maximum number of RIPng
packets that can be sent at
each interval.
4.
Return to system view.
5.
Enter interface view.
6.
Set the interval for sending
RIPng
maximum number of RIPng
packets that can be sent at
each interval.
Command
ripng
[
vpn-instance-name ]
checkzero
Command
system-view
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
maximum load-balancing number
Command
system-view
ripng
[
vpn-instance-name ]
packets
and
the
output-delay time count count
quit
interface
interface-number
packets
and
the
ripng output-delay time count
count
[
process-id
]
vpn-instance
[
process-id
]
vpn-instance
interface-type
384
Remarks
N/A
By default, zero field check is
enabled
for
incoming
packets.
Remarks
N/A
N/A
By default, the maximum number
of ECMP routes equals the
maximum
number
of
routes supported by the system.
Remarks
N/A
N/A
By default, a RIPng process
sends a maximum of three RIPng
packets every 20 milliseconds.
N/A
N/A
By default, an interface uses the
RIPng
packet
sending
configured for the RIPng process
that the interface runs.
RIPng
ECMP
rate

Advertisement

Table of Contents
loading

Table of Contents