Setting A Preference For Rip; Configuring Rip Route Redistribution - HP FlexFabric 12900E Series Configuration Manual

To configure route filtering:
Step
1. Enter system view.
2. Enter RIP view.
3. Configure the filtering of
received routes.
4. Configure the filtering of
redistributed routes.

Setting a preference for RIP

If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest
priority is selected as the optimal route. Perform this task to assign a preference to RIP. The smaller
the preference value, the higher the priority.
To set a preference for RIP:
Step
1. Enter system view.
2. Enter RIP view.
3. Set a preference for RIP.

Configuring RIP route redistribution

Perform this task to configure RIP to redistribute routes from other routing protocols, including OSPF,
IS-IS, BGP, static, and direct.
To configure RIP route redistribution:
Step
1. Enter system view.
2. Enter RIP view.
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
filter-policy { ipv4-acl-number
gateway prefix-list-name | prefix-list
prefix-list-name [
prefix-list-name ]
[ interface-type interface-number ]
filter-policy { ipv4-acl-number
prefix-list prefix-list-name } export
[ protocol [ process-id ] | interface-type
interface-number ]
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
preference { preference
route-policy route-policy-name }
*
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
31
Remarks
N/A
N/A
By default,
received
|
configured.
gateway
This command filters received
import
}
routes. Filtered routes are not
installed into the routing table or
advertised to neighbors.
By default,
redistributed
|
configured.
This
redistributed routes, including
routes redistributed with the
import-route command.
Remarks
N/A
N/A
|
The default setting is 100.
Remarks
N/A
N/A
the filtering of
routes is not
the filtering of
routes is not
command filters