Displaying And Maintaining Ripng; Ripng Configuration Examples; Basic Ripng Configuration Example - HP FlexFabric 12900E Series Configuration Manual

Displaying and maintaining RIPng

Execute display commands in any view and reset commands in user view.
Task
Display configuration information for a
RIPng process.
Display routes in the RIPng database.
Display RIPng GR information.
Display interface information for a RIPng
process.
Display neighbor information for a RIPng
process.
Display RIPng NSR information.
Display the routing information for a RIPng
process.
Restart a RIPng process.
Clear statistics for a RIPng process.

RIPng configuration examples

Basic RIPng configuration example

Network requirements
As shown in
route 2::/64 learned from Switch A and to forward only the route 4::/64 to Switch A.
Figure 90 Network diagram
Vlan-int400
2::1/64
Switch A
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic RIPng:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
Figure 90, Switch A, Switch B, and Switch C run RIPng. Configure Switch B to filter the
Vlan-int100
1::1/64
Vlan-int100
1::2/64
Switch B
Command
display ripng [ process-id ]
display ripng
process-id
prefix-length ]
display ripng [ process-id ] graceful-restart
display ripng process-id
interface-number ]
display ripng process-id
interface-number ]
display ripng [ process-id ] non-stop-routing
display ripng process-id route [ ipv6-address prefix-length
[ verbose ] | peer ipv6-address | statistics ]
reset ripng process-id process
reset ripng process-id statistics
Vlan-int600
Vlan-int200
3::1/64
Vlan-int200
3::2/64
Switch C
388
database
[
interface [
neighbor [
4::1/64
Vlan-int500
5::1/64
ipv6-address
interface-type
interface-type