HP FlexFabric 12900E Series Configuration Manual page 28

•
Configure a static route to subnet 120.1.1.0/24 on Switch A.
•
Configure a static route to subnet 121.1.1.0/24 on Switch B.
•
Enable BFD for both routes.
•
Configure a static route to subnet 120.1.1.0/24 and a static route to subnet 121.1.1.0/24 on
Switch C.
When the link between Switch A and Switch B through the Layer 2 switch fails, BFD can detect the
failure immediately. Switch A then communicates with Switch B through Switch C.
Figure 3 Network diagram
121.1.1.0/24
Switch A
Vlan-int11
Table 4 Interface and IP address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure static routes and BFD:
# Configure static routes on Switch A and enable BFD control mode for the static route that
traverses the Layer 2 switch.
<SwitchA> system-view
[SwitchA] interface vlan-interface 10
[SwitchA-vlan-interface10] bfd min-transmit-interval 500
[SwitchA-vlan-interface10] bfd min-receive-interval 500
[SwitchA-vlan-interface10] bfd detect-multiplier 9
[SwitchA-vlan-interface10] quit
[SwitchA] ip route-static 120.1.1.0 24 vlan-interface 10 12.1.1.2 bfd control-packet
[SwitchA] ip route-static 120.1.1.0 24 vlan-interface 11 10.1.1.100 preference 65
[SwitchA] quit
# Configure static routes on Switch B and enable BFD control mode for the static route that
traverses the Layer 2 switch.
<SwitchB> system-view
[SwitchB] interface vlan-interface 10
L2 Switch
Vlan-int10
Vlan-int10
BFD
Vlan-int11 Vlan-int13
Switch C
Interface
VLAN-interface 10
VLAN-interface 11
VLAN-interface 10
VLAN-interface 13
VLAN-interface 11
VLAN-interface 13
120.1.1.0/24
Switch B
Vlan-int13
IP address
12.1.1.1/24
10.1.1.102/24
12.1.1.2/24
13.1.1.1/24
10.1.1.100/24
13.1.1.2/24
16