Table of Contents
Advertisement
7.6.4.2 Assigning a Specific IP Address
To assign a specific IP address to the KWS600v3, it is necessary to disable the DCHP
mode and then assign a specific IP address to the KWS600v3. The new IP address and
network address will be provided by the system administrator.
Note: It is advisable that the IP addresses for KWS600v3 secondaries are numbered in
succession; eg. 192.168.1.3, 192.168.1.4, 192.168.1.5 etc. This makes it easier to detect a
specific Secondary KWS600v3.
Under the Configuration menu, click ETH0, and then click DHCP.
1
Figure 51 Adm. Page: Configuration/ETH0/DHCP page
From the Mode list, select Disabled, and then click OK.
2
Click Reset (under Administration menu) to save your configuration.
3
Under the Configuration menu, click ETH0, and then click IP.
4
Note: It is necessary to use the ETH0 port when integrating the KWS600v3 on the
local network.
Figure 52 Adm. Page: Configuration/ETH0/IP page
Configuring KIRK Wireless Server 600v3
(Secondary)
KIRK Wireless Server 600v3 Installation and Configuration Guide
111
Advertisement
Table of Contents
