Intrinsic Safety; Exposure To Sunlight, Heat And Moisture - Polycom KIRK 14117800 Installation And Configuration Manual

Polycom wireless server installation and configuration guide

Table of Contents

6 The product should be operated only from the type of power source indicated on the

instructions. If you are not sure of the type of power supply, consult your dealer or

local power company.

7 Do not overload wall outlets and extension cords as this can result in fire or electrical

shock.

8 Never push objects of any kind into this product through cabinet slots as they may

touch dangerous voltage points or short out parts that could result in fire, electrical

shock, or injury. Never spill liquid of any kind into this product.

9 To reduce the risk of electrical shock or burns, do not disassemble this product. Open-

ing or removing covers may expose you to dangerous voltages, dangerous electrical

current, or other risks. Incorrect reassemble can cause electrical shock when the appli-

ance is subsequently used. If the product need repair, consult your dealer.

10 This product does not support connections to outside plant.

11 Refer servicing to qualified service personnel under the following conditions:

AQ If liquid has been spilled into the product

BQ If the product has been exposed to rain or water

CQ If the product does not operate normally when following the operating instructions

in the manual. Adjust only those controls that are covered by the operation instruc-

tions. Improper adjustment of other controls may result in damage and will often

require extensive work by qualified service personnel to restore the product to nor-

mal operation.

DQ If the product has been dropped or cabinet has been damaged

EQ If the product exhibits a distinct change in performance

2 Avoid using telephone during an electrical storm. There may be a risk of electrical

shock from lightning

3 Do not use the telephone to report a gas leak in the vicinity of the leak

4 Do not place the unit near microwave ovens, radio equipment, or non-ground con-

nected televisions. These appliances may cause electrical interference to the base or

handset

5 The unit must be installed on a hard, plane surface and connected to a functional 120

volt AC power netadapter and plug the adapter into the power outlet

6 The system will not operate in the event of a blackout. Please keep a backup phone for

emergencies