Table of Contents
Advertisement
Configuring KIRK Wireless Server 600v3
96
In the Password fields, type the passwords.
3
Select the Write Access check box.
4
Click OK.
5
Click Reset (under Administration menu) to save your configuration.
6
7.6.1.6 Configuring DECT System
Under the Configuration menu, click DECT, and then click System.
1
Figure 33 Adm. Page: Configuration/DECT/System page
In the Name field, the name MUST ALWAYS be DECT.
2
If changing the name, the system cannot operate.
In the PWD (password) field, type the password, and then type it again in the field
3
below.
In the Sys-Mask field, when having repeaters on the system, you must type either:
4
• 0x3f (up to 64)
Repeaters with higher radio ID than 64 with offset 64 will perform bearer handover.
• 0x7f (up to128)
Repeaters with higher radio ID than 128 with offset 64 will perform bearer handover.
• 0xff (up to 256)
Repeaters connected will only perform connection handover.
From the Subscriptions list, select either With User AC, With system AC or Disable.
5
14117800, Ed.2.6
(Primary)
Advertisement
Table of Contents
