Under the Configuration menu, click ETH0, and then click DHCP.
1
Figure 37 Adm. Page: Configuration/ETH0/DHCP page
From the Mode list, select Disabled, and then click OK.
2
Click Reset (under Administration menu) to save your configuration.
3
Under the Configuration menu, click ETH0, and then click IP.
4
Note: It is necessary to use the ETH0 port when integrating the KWS600v3 on the
local network.
Figure 38 Adm. Page: Configuration/ETH0/IP page
In the IP address field, type the new IP address.
5
The new IP address is now the default address when accessing the KWS600v3.
In the Network mask field, type a new network mask.
6
In the Default gateway field, type the IP address of the default gateway.
7
Contact your system administrator for more information.
Click OK.
8
Configuring KIRK Wireless Server 600v3
KIRK Wireless Server 600v3 Installation and Configuration Guide
101