Table of Contents
Advertisement
Configuring KIRK Wireless Server 600v3
122
Under the Configuration menu, click LDAP, and then click Replicator.
1
Figure 64 Adm. Page: Configuration/LDAP/Replicator page
In the Server field, type the IP address of the LDAP Server.
2
In the User name field, type the user name.
3
In the Password field, type the password.
4
Select the Enable check box.
5
Click OK.
6
Click Reset (under Administration menu) to save your configuration.
7
The alternative LDAP Server is now configured.
7.7 Configuring Single-Cell Solution through KIRK Configuration Tool
Note: Using the Configuration Tool is recommended when configuring medium-sized to
large installations. It is possible, though, to use the Configuration Tool for single-cell
configuration as well.
For information on accessing the Configuration Tool, refer to
Configuration Tool" on page
This section describes how to configure a KWS600v3 Single-cell solution.
14117800, Ed.2.6
81.
"Accessing the KIRK
Advertisement
Table of Contents
