First Entry Power-Up And Configuration; Modify Network Settings In Usb Key - Polycom RealPresence Collaboration Server Virtual Edition 1800 Getting Started Manual

Procedure
• Connect the E1/T1 cables to PRI.
• Connect the LAN cable to LAN 1 ports.
When LAN redundancy is enabled, LAN 1 is used for both management, media and signaling
network connection. Connect the media and signaling cable to LAN 2 port. By default this port is
used for signaling, but when LAN redundancy is enabled, LAN 2 is the backup of LAN 1 port.
Connect Cables to the 9 PRI Ports, 4 LAN Ports RTM ISDN Card
To connect cables to the 9 PRI ports, 4 LAN ports RTM ISDN card:
Procedure
1. Connect the E1/T1 cables to PRI.
2. In MPMRx card mode, connect the LAN cable to LAN1 and LAN 2.
RealPresence Collaboration Server (RMX) 4000 rear panel with AC powers and communication cables

First Entry Power-up and Configuration

Before power up the system for the first time, you must configure it to your local network settings using
the LAN Configuration Utility in the USB Key.

Modify Network Settings in USB Key

The USB Key contains a text file, lan.cfg, which holds the factory default IP address parameters. These
parameters must be modified to your local network settings using the LAN Configuration Utility in the
USB Key.
Note: LAN configuration utility
The RealPresence Collaboration Server (RMX) 1800 must use the LAN configuration utility in a
USB Key to change the IP address.
Polycom, Inc.
Appliance Edition Installation
30