Configuring The Source Ipv6 Addresses For Mld Queries - HP A8800 Configuration Manual

Step
4. Set the MLD last-listener query
interval.
Configuring the parameters for MLD queries and responses in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the interval for sending
MLD general queries.
Set the maximum response
4.
delay for MLD general
queries.
5. Set the MLD last-listener query
interval.

Configuring the source IPv6 addresses for MLD queries

Step
1. Enter system view.
2. Enter VLAN view.
3. Configure the source IPv6
address of MLD general
queries.
4. Configure the source IPv6
address of MLD
multicast-address-specific
queries.
IMPORTANT:
The source IPv6 address of MLD query messages may affect MLD querier election within the segment.
Configuring MLD snooping proxying
Before configuring MLD snooping proxying in a VLAN, complete the following tasks:
Enable MLD snooping in the VLAN.
•
Determine the source IPv6 address for the MLD reports sent by the proxy.
•
Determine the source IPv6 address for the MLD done messages sent by the proxy.
•
Command
last-listener-query-interval interval
Command
system-view
vlan vlan-id
mld-snooping query-interval
interval
mld-snooping max-response-time
interval
mld-snooping
last-listener-query-interval interval
Command
system-view
vlan vlan-id
mld-snooping general-query
source-ip { ipv6-address |
current-interface }
mld-snooping special-query
source-ip { ipv6-address |
current-interface }
300
Remarks
1 second by default.
Remarks
N/A
N/A
125 seconds by default.
10 seconds by default.
1 second by default.
Remarks
N/A
N/A
FE80::02FF:FFFF:FE00:0001 by
default.
FE80::02FF:FFFF:FE00:0001 by
default.