YASKAWA SGD7S-R70A Product Manual page 260

JOG Speed Table Initialization (Fn065)
This function initializes JOG speed tables and restores the default settings.
 Preparation
The following conditions must be met to initialize JOG speed tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• A JOG speed table initialization must not be in progress for any means other than the digital
operator.
 Operating Procedure
Step Display after Operation
1
2
3
4
5
*
If the key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and
then the display returns to the Fn065 operation screen. In this case, make the setting again by referring to
Preparation.
10.2.2 Operation of Utility Functions
Keys
Press the key to open the Utility Function
Mode main menu, and move the cursor with the
keys to select Fn065.
Press the key to view the Fn065 operation
screen.
Press the key to start JOG speed table ini-
tialization.*
Do not turn OFF the control power supply until
initialization has been completed normally.
To cancel the Fn065 operation, press the
key before pressing the
returns to the Utility Function Mode main menu
without executing the operation.
When JOG speed table initialization has been
–
completed normally, "Done." is displayed.
Press the key to return to the Utility Function
Mode main menu.
10.2 Operation of Digital Operator
Operation
key. The display

10
10-19