YASKAWA SGD7S-R70A Product Manual page 254

ZONE Table Edit/Save (Fn061)
This function edits and saves ZONE tables. Saving a ZONE table to flash memory after editing
it ensures that the data will be retained even after the control power has been turned OFF.
 Codes Displayed on the ZONE Table Editing Screen
For details on how to read the screen, refer to Reading the Screen on page 10-6.
ZONE
ZONE P
Number
0 ZP000
1 ZP001
7 ZP007
 Preparation
The following conditions must be met to edit and save ZONE tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• A ZONE table save operation must not be in progress for any means other than the digital
operator.
 Editing ZONE Tables
The operating procedure when setting ZONE N in ZONE number 5 is explained here.
Step Display after Operation
1
2
3
4
5
6
Repeat steps 3 to 6 to set the ZONE table. On completing the setting of all the ZONE tables to be
7
used, save the ZONE tables to flash memory by following the procedure in
*
If setting is attempted in an operation prohibited state, it will not be possible to change the setting. In this case,
make the setting again by referring to
ZONE N
ZN000
ZN001
ZN007
Keys

Preparation.
10.2 Operation of Digital Operator
10.2.2 Operation of Utility Functions
Operation
Press the key to open the Utility Function
Mode main menu, and move the cursor with the
keys to select Fn061.
Press the key to view the Fn061 operation
screen.
Move the cursor using the
keys to select the ZONE table number to
be edited. Refer to the following section for details
on the methods to move the cursor.

Method for Moving the Cursor on page 10-9
Press the key to move the cursor to the set-
ting side of the table.
Move the cursor using the
change the ZONE boundary values using the
keys.*
Press the key to enter the setting. The cursor
returns to the ZONE table number side.

Saving ZONE Tables.
keys and
keys and
10
10-13