YASKAWA SGD7S-R70A Product Manual page 217

Parameter
Name
No.
Position Control Refer-
2
ence For Selections
Reference Pulse Form

n. X
Clear Signal Form
Pn200
 
n. X
Clear Operation
 
n. X
Filter Selection

n.X
Pn205 2 Multiturn Limit
Position Control Func-
2
tion Selections

n. X Reserved parameter (Do not change.)
Position Control Option
 
n. X
 
n. X Reserved parameter (Do not change.)
Pn207
/COIN (Positioning Completion Output) Signal Output Timing

n.X
Setting Setting
Range Unit
0000h to
–
2236
h
0 Sign and pulse train, positive logic.
1 CW and CCW pulse trains, positive logic
Two-phase pulse trains with 90° phase differential (phase A and
2
phase B) ×1, positive logic
Two-phase pulse trains with 90° phase differential (phase A and
3
phase B) ×2, positive logic
Two-phase pulse trains with 90° phase differential (phase A and
4
phase B) ×4, positive logic
5 Sign and pulse train, negative logic.
6 CW and CCW pulse trains, negative logic
0 Clear position deviation when the signal is at high level.
1 Clear position deviation on the rising edge of the signal.
2 Clear position deviation when the signal is at low level.
3 Clear position deviation on the falling edge of the signal.
Clear position deviation at a base block (at servo OFF or when
0
alarm occurs).
Do not clear position error (cleared only with CLR (Clear Position
1
Deviation) signal).
2 Clear position deviation when an alarm occurs.
0 Use reference input filter 1 for a line-driver signal. (1 Mpps max.)
Use the reference input filter for an open-collector signal. (200
1
kpps max.)
2 Use reference input filter 2 for a line-driver signal. (1 to 4 Mpps)
0 to 65,535 1 rev
0000h
to
–
2210 h
0 Do not use V-REF.
1 Use V-REF as a speed feedback input.
Output when the absolute value of the position deviation is the
0 same or less than the setting of Pn522 (Positioning Completed
Width).
Output when the absolute value of the position error is the same
1 or less than the setting of Pn522 (Positioning Completed Width)
and the reference after the position reference filter is 0.
Output when the absolute value of the position error is the same
2 or less than the setting of Pn522 (Positioning Completed Width)
and the reference input is 0.
9.2 List of Parameters
9.2.2 List of Parameters
Continued from previous page.
Default Applicable When
Setting Motors Enabled
After
0000 All
h
restart
After
65535 Rotary
restart
After
2000h All
restart
Continued on next page.
Classi- Refer-
fication ence
Setup –
Reference
*1
Reference
*1
Reference
*1
Reference
*1
*1
Setup
Setup –
Reference
*1
Reference
*1
9
9-17