YASKAWA SGD7S-R70A Product Manual page 257

10.2 Operation of Digital Operator
10.2.2 Operation of Utility Functions
Step
6
7
*
If setting is attempted in an operation prohibited state, it will not be possible to change the setting. In this case,
make the setting again by referring to
 Saving JOG Speed Tables
The operating procedure for saving JOG speed tables is shown below.
Step
1
2
3
4
5
6
*
If the
then the display returns to the JOG speed table editing screen. In this case, make the setting again by referring to

Preparation.
10-16
Display after Operation
Repeat steps 3 to 6 to set the JOG speed table. On completing the setting of all the JOG speed
tables to be used, save the JOG speed tables to flash memory by following the procedure in
ing JOG Speed Tables.
Display after Operation
key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and
Keys
Press the
returns to the JOG speed table number side.

Preparation.
Keys
– Display the JOG speed table editing screen.
Press the
save screen.
Move the cursor with the
"STORE".
Note: Selecting "CANCEL" and pressing the
Press the
table to flash memory.*
Do not turn OFF the control power supply until
saving has been completed normally.
When saving to flash memory has been com-
– pleted normally, the display returns to the JOG
speed table editing screen.
Press the
Mode main menu.
Continued from previous page.
Operation
key to enter the setting. The cursor
Operation
key to view the JOG speed table
return the display to the JOG speed table editing
screen.
key to start saving the JOG speed
key to return to the Utility Function

Sav-
keys to select
key will