YASKAWA SGD7S-R70A Product Manual page 100

2.
Set the acceleration and deceleration rates.
The Same as previous step Check Boxes are selected by default.
To use different values from the previous step, clear the selections of the Same as previous step
Check Boxes and enter the values directly.
Unit
1,000 reference units/min/ms
3.
Click the OK Button.
This concludes the setting procedure.
If you select the Same as previous step Check Boxes for the starting program step, the set-
Information
tings of the acceleration/deceleration parameters (Pn63E: acceleration rate, Pn640: deceler-
ation rate) that were set before programmed operation was started will be used.
Setting Range Default Setting
1 to 199,999,999
7.3 Program Table Operation
7.3.5 SigmaWin+ Procedures
:
7
7-19