YASKAWA SGD7S-R70A Product Manual page 252

 ACC: Acceleration
Note: Refer to the following section for details on the acceleration rate.
7.3.4 Settings in the Program Table on page 7-13
 DEC: Deceleration
Note: Refer to the following section for details on the deceleration rate.
7.3.4 Settings in the Program Table on page 7-13
 POUT: Programmable Output Signals
Note: Refer to the following section for details on the programmable output signals.
7.3.4 Settings in the Program Table on page 7-13
 EVENT: Pass Condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass condition
Note: 1. Refer to the following section for details on the pass condition and elapsed time.
7.3.4 Settings in the Program Table on page 7-13
2. The default setting is EVT000 = IT00000.
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
10.2 Operation of Digital Operator
10.2.2 Operation of Utility Functions
Change acceleration
If the value becomes less than 1,
":" is displayed.
Change deceleration
If the value becomes less than 1,
":" is displayed.
Change programmable output signal
Pressing the key changes the display
in the following order.
Pressing the key changes the display
in the reverse order.
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
10
10-11