YASKAWA SGD7S-R70A Product Manual page 258

Program Table Initialization (Fn063)
This function initializes the program tables and restores the default settings.
 Preparation
The following conditions must be met to initialize the program table.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• The program must not be running or on hold.
• A program table initialization must not be in progress for any means other than the digital
operator.
 Operating Procedure
Step Display after Operation
1
2
3
4
5
*
If the key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and
then the display returns to the Fn063 operation screen. In this case, make the setting again by referring to
Preparation.
10.2.2 Operation of Utility Functions
Keys
Press the key to open the Utility Function
Mode main menu, and move the cursor with the
keys to select Fn063.
Press the key to view the Fn063 operation
screen.
Press the key to start program table initial-
ization.*
Do not turn OFF the control power supply until
initialization has been completed normally.
To cancel the Fn063 operation, press the
key before pressing the
returns to the Utility Function Mode main menu
without executing the operation.
When program table initialization has been com-
–
pleted normally, "Done." is displayed.
Press the key to return to the Utility Function
Mode main menu.
10.2 Operation of Digital Operator
Operation
key. The display

10
10-17