YASKAWA SGD7S-R70A Product Manual page 256

Step Display after Operation
5
6
*
If the key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and
then the display returns to the ZONE table editing screen. In this case, make the setting again by referring to
Preparation.
JOG Speed Table Edit/Save (Fn062)
This function edits and saves JOG speed tables. Saving a JOG speed table to flash memory
after editing it ensures that the data will be retained even after the control power has been
turned OFF.
Refer to the following section for information on interpreting the displays.
Reading the Screen on page 10-6
 Preparation
The following conditions must be met to save and edit JOG speed tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• A JOG speed table save operation must not be in progress for any means other than the dig-
ital operator.
 Editing JOG Speed Tables
The operating procedure when setting the value for JOG speed table number 5 is explained
here.
Step Display after Operation
1
2
3
4
5
10.2.2 Operation of Utility Functions
Keys
When saving to flash memory has been completed
– normally, the display returns to the ZONE table
editing screen.
Press the key to return to the Utility Function
Mode main menu.
Keys
Press the key to open the Utility Function
Mode main menu, and move the cursor with the
keys to select Fn062.
Press the key to view the Fn062 operation
screen.
Move the cursor using the
the JOG speed table number to be edited.
Pressing the
speed table number 0 moves it to number 7.
Pressing the
speed table number 7 moves it to number 0.
Press the key to move the cursor to the set-
ting side of the table.
Move the cursor with the
change the JOG speed setting with the
keys.*
10.2 Operation of Digital Operator
Continued from previous page.
Operation

Operation
keys to select
key when the cursor is on JOG
key when the cursor is on JOG
keys, and
Continued on next page.
10
10-15