Panasonic KX-T336 System Reference Manual page 166

[Note]
a) When you start up the system after installation, the Operation Switch (MODE) should be set to "5" or
"6."
• No.5 ....When you program the system data based on the factory programmed default values.
• No.6 ....When you program the system data without the factory programmed default values.
b) When system programming is finished, the Operation Switch (MODE) should be set to "0," "1" or "2."
• No.0 .....When CPU runaway occurs due to a loss of system programming data or the RESET button is
pressed, the system enters to on-line mode if system programming data is verified logically, or
the system enters to off-line mode if system programming data is not verified logically.
• No.1 ....When CPU runway occurs due to a loss of system programming data or the RESET button is
pressed, default value is loaded and the system enters to on-line mode.
If system programming data is not lost, reset-routine will be activated and enters to on-line
mode with the current system programming data.
• No.2 ....When CPU runaway occurs due to a loss of system programming data or the RESET button is
pressed, the system enters to off-line mode with the current System programming data.
c) With System Memory
System memory is provided.
d) Without System Memory
System memory is not provided.
e) Off-line
It is available to perform system data programming but call processing and functional test are not
available in off-line mode.
f) Power failure transfer
Connects preassigned CO lines and extensions directly, bypassing the system.
g) After you entered the system administration mode, keep the following considerations in mind when
setting the Operation Switch.
• No.5 ....Current programming data will be defaulted.
• No.6 ....Current programming data will be removed.
2-F-3