Flexible Numbering - Panasonic KX-T336 System Reference Manual

B. Basic Features

1.00 Flexible Numbering

Description
This system comes with a variety of services,
and the feature numbers used when executing
these services can be set as required.
Feature numbers can be from one to four digits,
utilizing numbers "0" through "9" as well as "* "
and "#."
Directory Numbers (DN) can be three or four
digits in length, and it is acceptable for some to
have three digits and others four digits.
When three-digit DN's are used, any number can
be set as the initial digit; when four-digit DN's are
used, any numbers can be set as the initial two
digits.
The feature numbers are set in the "System-
Numbering Plan" screens.
Two default parameters sets are provided for the
feature numbers and when either is used in its
original form, the Numbering Plan option in the
"System-Operation" screen is set to "Fixed 1" or
"Fixed 2."
In this case, the settings cannot be changed in
the "System-Numbering Plan" screen. When a
feature number is to be changed, select Flex in
the "System-Operation", Numbering Plan before
making the change in the "System-Numbering
Plan."
Programming
System Programming
"System-Operation (1/3)",
Numbering Plan
"System-Numbering Plan"
Reference
VT Dumb
9-D-1.01 10-C-4.00
10-C-10.00
9-D-6.01
to 6.09
3-B-1
Conditions
The followings are examples of feature number
conflicts:
Examples: 2 and 21, 32 and 321, etc.
Conversely, the following numbers can be used
without conflict:
Examples: 2 and 3, 3 and 41, 41 and 42, 450
and 451, etc.
"* " and "#" cannot be used for extension
numbers (extension blocks).
When "* " and "#" are included in a feature
number, it will not be possible to execute the
corresponding feature using a dial pulse type of
Single Line Telephone (SLT).
Only "0", "1" to "9", "* " and "#" are valid for
entering feature numbers into One Touch dial
buttons.
When "FLASH", "-" ,"PAUSE" and "SECRET" are
included into feature numbers, reorder tone is
sent and the features cannot be executed.
"#" cannot be used for the feature numbers listed
below, for those features require "#" as a
delimiter when setting the feature:
"Call Forwarding-to Trunk"
"Pickup Dialing Programming"
"Speed Dialing-Station"
The feature numbers which have been set in the
"System-Numbering Plan" screens can be used
when dial tone is heard. However, feature
number for "Account Code" may be used at times
other than when dial tone is heard.