Panasonic KX-T336 System Reference Manual page 33

3.00 Programming
Before starting up the basic system data
programming, general feature description must
be read.
For further information about general feature
description, refer to Section 3 "System Features
and Operation."
Basic system data programming can be done
using VT220, compatibles, dumb terminal and
attendant console.
(VT220 and Compatibles user)
Refer to Section 7 "Preparation for Programming
and Maintenance (VT220 and Compatibles)" and
Section 9 "System Programming (VT220 and
Compatibles)."
(Dumb terminal user)
Refer to Section 8 "Preparation for Programming
and Maintenance (Dumb)" and Section 10
"System Programming (Dumb)."
4.00 Test
System's built-in maintenance capabilities and
the basic diagnostics in fault diagnosis and
corrective maintenance are described in Section
14 "Maintenance (VT220 and Compatibles)" and
Section 15 "Maintenance (Dumb)."
Self-Test (System-Detected Troubles)
System's built-in on-line diagnostic test program
monitors the troubles generated by hardware or
software during on-line communication mode.
(VT220 and Compatibles user)
Refer to Section 14-D "Self-Test (System-
Detected Troubles)" for further information.
(Dumb terminal user)
Refer to Section 15-D "Self-Test (System-
Detected Troubles)" for further information.
Functional test by entering commands
Functional test is done by entering specific test
commands when you install the new device and
so on.
(VT220 and Compatibles user)
Refer to Section 14-F "Functional Test by
Entering Commands" for further information.
(Dumb terminal user)
Refer to Section 15-E "Functional Test by
Entering Commands" for further information.
1-D-2