9
2
1
Assembling damper
•
Insert the rubber dampers (7) into the damper
housing (6).
L
Note:
New parts must be oiled lightly.
•
Push the retaining plate (4) onto the output
shaft (3), slightly heat the inner part of the
damper (5) and press it into position on the shaft.
•
Push the damper housing on to the output shaft.
Assembling engine
Installing output shaft
•
Push the snap ring (2) and the needle roller
race (1) onto the output shaft.
•
Place the output shaft in the crankcase.
2
8
4
3
L
Note:
Make sure that the open end of the snap ring (arrow)
is facing downward in the crankcase.
•
Install O-rings (8, 9) for the water and oil passages.
Assembling the crankcase
•
Check that sealing face is clean and degreased
and apply a thin coat of Omni VISC 1002, see
black line on sealing face with grey shading.
•
Fill the expansion grooves (arrows) with sealing
compound.
L
9
Note:
Remove excess sealant with a spatula.
KR110521
6
5
7
KR110451
KL110250
11.37