Removing And Installing Gearshift Lever And Linkage; Removing And Installing Gearshift Lever - BMW K 1200 LT 1999 Repair Manual

10
9
Removing and installing gearshift
lever and linkage
•
Slacken screws securing front footrest plate.
•
Remove retainer pin (2).
•
Disengage gearshift linkage at ball joint (1).
•
Remove front footrest plate.
•
Remove bearing screw (8).
•
Remove retaining pin (5).
•
Disengage gearshift linkage at ball joint (6).
•
Remove relay lever (3).
•
Remove selector lever (7).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Note mark (arrow) on gearshift lever.
•
Lubricate bearing bushing (4) with
Staburags NBU 30 PTM or equivalent.
L
Note:
Ball joint (1) on gearshift lever is secured with lock-
ing compound. After removal of ball joint (1) clean
threads and install with small washer and
Loctite 2701.
X
Tightening torques:
Relay lever to cross tube ................................ 9 Nm
Pinch bolt of gearshift lever (7) ....................... 9 Nm
Ball head (1) to gearshift lever
(clean thread + Loctite 2701........................... 8 Nm
23.40
2
1
3
8
Removing and installing gearshift
lever
•
•
•
•
•
X
Gearshift lever to footrest plate
(clean thread and Loctite 243)...................... 41 Nm
4
Remove screw (10).
Remove gearshift lever with bearing bushing (9).
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
Lubricate bearing bushing (9) with
Staburags NBU 30 PTM or equivalent.
Clean threads of screw (10), coat with
Loctite 243 and install.
Tightening torques:
5
6
7
KL230030